NMB15-30GM65-E2-V1 Inductive sensor

Key Benefits at a Glance

15 mm flush
Stainless steel sensing face
Increased operating distance

Product photo: Inductive sensor NMB15-30GM65-E2-V1

Dimensions: Inductive sensor NMB15-30GM65-E2-V1

Note

All product-related documents, such as certificates, declarations of conformity, etc., which were issued prior to the conversion under the name Pepperl+Fuchs GmbH or Pepperl+Fuchs AG, also apply to Pepperl+Fuchs SE.

EN

EN
CS
DE
ES
FR
IT
PL
PT
SV

Datasheet Classification Product Documentation Design / Simulation Approvals Related Products

Technical data of NMB15-30GM65-E2-V1

Switching function		Normally open (NO)
Output type		PNP
Rated operating distance	s_n	15 mm
Installation		flush (Requirements: see drawing below)
Output polarity		DC
Assured operating distance	s_a	0 ... 12.15 mm
Actuating element		Ferrous and nonferrous targets
Reduction factor r_Al		0.4
Reduction factor r_Cu		0.2
Reduction factor r₃₀₄		0.85
Reduction factor r_St37		1
Output type		3-wire

Operating voltage	U_B	10 ... 30 V DC
Switching frequency	f	0 ... 150 Hz
Hysteresis	H	3 ... 15 typ. 10 %
Reverse polarity protection		reverse polarity protected
Short-circuit protection		pulsing
Voltage drop	U_d	≤ 2 V
Operating current	I_L	≤ 200 mA
Off-state current	I_r	≤ 10 µA
No-load supply current	I₀	≤ 15 mA
Operating voltage indicator		LED, green
Switching state indicator		LED, yellow

MTTF_d		893 a
Mission Time (T_M)		20 a
Diagnostic Coverage (DC)		0 %

Standard conformity

Standards

EN IEC 60947-5-2

UL approval		cULus Listed Load Type: General Purpose Circuitry: Class 2 Power Source Enclosure Type Rating: Type 1 Supply/Switching Voltage: 30 V DC Output Switching Current: 200 mA
CCC approval		CCC approval / marking not required for products rated ≤36 V

Ambient temperature

-25 ... 70 °C (-13 ... 158 °F)

Connection type

Connector plug

Housing material

Stainless steel 1.4305 / AISI 303

Sensing face

Stainless steel 1.4305 / AISI 303

Degree of protection

IP67 / IP68 / IP69K - cordset dependent according to cable specification

Connector

Threading		M12 x 1
Number of pins		4

Dimensions

Length		65 mm
Diameter		30 mm

General Notes